Bürkert
Direkte virkende 2/2-vejs eller 3/2-vejs klapankerventil
Type 0330 / Produktnr. 311995
Produktbeskrivelse
Ventilen 0330 er en direkte virkende, mediesepareret klapankerventil. Den fås i 3/2-vejs og 2/2-vejs udførelser. I 3/2-vejs-udførelsen kan den anvendes som fordeler- eller blandeventil. Svarende til applikationerne fås forskelige membranmaterialer og funktioner. Standardventilhuset af messing opfylder alle europæiske drikkevandskrav. Udbuddet af ventilhuse afrundes med rustfrit stål (316L), PVDF og polypropylen. Et omgivende lag af epoxid med høj kemisk modstandsdygtighed bliver presset sammen omkring magnetspolerne. Til idriftsættelse og prøvning er 0330 udstyret med en manuel aktivering. Til reduktion af energibehovet kan alle spoler leveres med en elektronisk forbrugssænkning eller i en impulsudførelse. Skiftetilstanden kan aktiveres via en stillingstilbagemelding som binært signal eller NAMUR-signal. I forbindelse med et stik efter DIN EN 17301-803 form A opfylder ventilerne kravene for beskyttelsesart IP65/67, og i forbindelse med et ventilhus af rustfrit stål eller kunststof NEMA 4X.
- Statistiske varenumre
- 84818079
- Land
- DE
Tekniske egenskaber
Navn |
Værdi |
Enhed |
|---|---|---|
| Type | 0330 | |
| Operation | direct-acting | |
| Actuator type | Pivot | |
| Main valve operating principle | Globe valve | |
| Switch function | on/off | |
| Media separation | Yes | |
| Valve function | A - normally closed - inlet port 1 (P/NC) | |
| Fluidic port connection number | 2 | |
| Valve function number of switching positions | 2 | |
| Valve function manual actuation | Yes | |
| Valve function manual actuation type | Key button | |
| Valve function manual actuation material | PA (Polyamide) | |
| Flow | Above seat | |
| Nominal pressure min | -1 | bar |
| Nominal pressure max (liquid) | 1 | bar |
| Main valve orifice 1 (P) (mm) | 5 | mm |
| Main valve orifice 1 (inch) | 3/16 inch | |
| Kv value (water) | 0,4 | m3/h |
| QNn value (gas) | 440 | l/min |
| Main valve wetted material | PP (Polypropylene) | |
| Port connection 1 type | Inner thread | |
| Port connection 1 thread type | NPT | |
| Port connection 1 thread marking | 1/4 | |
| Port connection 2 type | Inner thread | |
| Port connection 2 thread type | NPT | |
| Port connection 2 thread marking | 1/4 | |
| Valve seat material | PP (Polypropylene) | |
| Seat seal material category | Elastomer | |
| Seat seal material | EPDM (Ethylene-propylene-diene rubber) | |
| Seat seal material Shore hardness | 70 | |
| Sealing toward outside material | EPDM (Ethylene-propylene-diene rubber) | |
| Temperature environment max | 55 | °C |
| Temperature medium min | -30 | °C |
| Temperature medium max | 80 | °C |
| Temperature surface max | 155 | °C |
| Voltage / rated voltage | 24 | V |
| Voltage / rated voltage | 24 | V |
| Voltage tolerance negative | 10 | % |
| Voltage tolerance positive | 10 | % |
| AC voltage | No | |
| DC voltage | Yes | |
| Battery voltage | Yes | |
| Rated power DC | 11 | W |
| Reduced power DC | 11 | W |
| Rated power consumption | 8 | W |
| Electrical connection sort | Plug pattern form A according to DIN EN 175301-803 | |
| Electrical connection number of contacts | 2 + Grounding conductor | |
| Electrical connection position | top | |
| Electrical connection wire length | 300 | mm |
| Electrical connection polarity | Irrelevant | |
| Electrical connection material | Brass | |
| Protection type (IP max. with suitable connector) | IP65 | |
| Coil type | block bolted | |
| Coil insulation material category (encasement) | Plastics | |
| Coil insulation material (encasement) | Epoxy | |
| Coil wiring overvoltage protection | without | |
| Coil wiring rectifier | No | |
| Coil wiring polarity protection | No | |
| Coil wiring polarity recovery diode | No | |
| Thermal insulation class of the actuator | H | |
| Nominal operation/Duty cycle | 40 | % |
| Switch time open min | 10 | ms |
| Switch time open max. | 20 | ms |
| Switch time close min | 10 | ms |
| Switch time close max. | 20 | ms |
| Valve setting opening time | No | |
| Valve setting closing time | No | |
| Back-pressure-resistant version | No | |
| Vacuum version | Yes | |
| Analysis version | No | |
| Oil burner valve | No | |
| Steam version | No | |
| Low-noise version | No | |
| Main valve with integrated screen | No | |
| Installation length | 56 | mm |
| Mounting type | Plastic-cutting screws | |
| Valve construction | Valve complete | |
| Vægt | 0,345000 | kg |
Kan kombineres med
Applikationer og værktøj
Downloads
Datablad
Beskrivelse |
Filstørrelse |
Sprog / Land |
|
|---|---|---|---|
|
Type 0330 data sheet | pivoted armature valve | 1,1 MB | EN / EU |
|
|
Type 0330 data sheet | pivoted armature valve for analytical applications [US units] | 303,5 kB | EN / US |
|
|
Typ 0330 Datenblatt | Klappanker-Magnetventil | 1,1 MB | DE / DE |
Brugermanualer
Beskrivelse |
Filstørrelse |
Sprog / Land |
|
|---|---|---|---|
|
|
Additional manual Type 6013 | PX04 Use in the explosion-hazard area | 138,7 kB | EN,FR,DE / EU |
|
|
Operating Instructions Type 012X 0330 033X | 2/2-way and 3/2-way solenoid valve | 1,8 MB | EN,FR,DE / EU |
|
|
Operating Instructions Type 0330 0331 | 2/2-way or 3/2-way solenoid valves, direct-acting | 571,2 kB | EN / EU |
|
|
Operating Instructions Type 0780 | ATEX approval | 1,5 MB | EN,FR,DE / EU |
|
|
Operating Instructions Type ACP016 | Solenoid coil ACP016, II 2G/D Ex approval | 1,5 MB | EN / EU |
|
|
Bedienungsanleitung Typ ACP016 | Magnetspule ACP016, II 2G/D Ex Zulassung | 1,5 MB | DE / DE |
|
|
Manuel d'utilisation Type ACP016 | Bobine magnétique ACP016, homologation II 2G/D Ex | 1,6 MB | FR / FR |
EU-erklæring
Beskrivelse |
Filstørrelse |
Sprog / Land |
|
|---|---|---|---|
|
|
EU-DoC|EU Declaration | 2,1 MB | EN,FR,DE |
Interaktiv animation
Beskrivelse |
Filstørrelse |
Sprog / Land |
|
|---|---|---|---|
|
|
3D-Animation - 0330 | 1,2 MB | EN |
Flyers og kataloger
Beskrivelse |
Filstørrelse |
Sprog / Land |
|
|---|---|---|---|
|
|
4,3 MB | EU | |
|
|
Solenoid valves for safety in your plant | 786,8 kB | EN / EU |