Bürkert - tæt på dig
Office /1
    • Hovedkontor
      Burkert Danmark A/S
      Hørkær 24
      2730 Herlev
      Telefon +45 44 50 75 00
      Telefax + 45 44 50 75 75
      E-mailadresse vasb.qx@ohexreg.pbz
  • Hovedkontor
  • Hovedkvarter
  • Systemhaus
  • Distributor
  • Office
  • Plant
  • Logistikcenter
bürkert
 

    This article number 00%number% is only available for a limited time.

    Defined wearing parts kits might still be available.

    Please contact us regarding a successor product.

    Servostyret 2/2-vejs stempelventil

    Type 2400 / Produktnr. 297122

    Produkt-Foto Typ 2400

    Billedet er til illustration og kan afvige fra det faktiske produkt.

    • Produkt-Foto Typ 2400
    • 9000131292.jpeg
    • 9000219076.jpeg
    • 9000219087.jpeg
    • 9000099170.jpeg

    2/2-way high pressure solenoid valve

    • Påsat spolesystem
    • Højtemperatur-version, op til 250 bar, op til DN 12
    • Hus i rustfrit stål

    For at vælge det rette produkt til formålet skal databladets tekniske oplysninger, illustrationer og anvisninger om korrekt brug af produktet iagttages.

    Produktbeskrivelse

    Den servostyrede ventil type 2400 har et servostempel med 2-vejs forstyring. Den er udviklet til høje tryk. Det særlige ved denne ventilmodel ligger i udformningen af sæde og tætningselement. En ekstra radial tætning giver en meget høj tæthed. Det kegleformede tætningselement på forstyringen muliggør regulering af høje tryk ved relativt lav spoleeffekt.


    Statistiske varenumre
    84818079
    Land
    DE

    Tekniske egenskaber

    Navn
    Værdi
    Enhed
    Type 2400
    Operation servo-controlled
    Actuator type Plunger valve
    Main valve operating principle Globe valve
    Switch function on/off
    Media separation No
    Valve function A - normally closed - inlet port 1 (P/NC)
    Fluidic port connection number 2
    Valve function number of switching positions 2
    Valve function manual actuation No
    Flow Above seat
    Nominal pressure min 1 bar
    Nominal pressure max (liquid) 200 bar
    Main valve orifice 1 (P) (mm) 5 mm
    Main valve orifice 1 (inch) 3/16 inch
    Kv value (water) 0.6 m3/h
    QNn value (gas) 640 l/min
    Main valve wetted material Brass
    Port connection 1 type Inner thread
    Port connection 1 thread type G
    Port connection 1 thread marking 1/4
    Port connection 2 type Inner thread
    Port connection 2 thread type G
    Port connection 2 thread marking 1/4
    Valve seat material Stainless steel
    Medium-contacting part core material Stainless steel
    Medium-contacting part stopper material Stainless steel
    Seat seal material category Plastics
    Seat seal material PCTFE (Polychlorotrifluoroethylene)
    Sealing toward outside material FKM (Fluor rubber)
    Temperature environment min -20 °C
    Temperature environment max 40 °C
    Temperature medium min -10 °C
    Temperature medium max 80 °C
    Voltage / rated voltage 24 V
    Voltage / rated voltage 24 V
    Voltage tolerance negative 0 %
    Voltage tolerance positive 0 %
    Voltage frequency 50/60 Hz
    AC voltage Yes
    DC voltage Yes
    Battery voltage Yes
    Rated power DC 20 W
    Reduced power DC 15 W
    Rated power consumption 15 W
    Electrical connection sort Plug pattern form A according to DIN EN 175301-803
    Electrical connection number of contacts 2 + Grounding conductor
    Electrical connection position in direction of flow left
    Electrical connection wire length 3000 mm
    Protection type (IP max. with suitable connector) 65
    Coil type placed on top
    Coil insulation material category (encasement) Plastics
    Coil insulation material (encasement) Epoxy
    Coil wiring overvoltage protection without
    Coil wiring rectifier No
    Coil wiring polarity recovery diode No
    Thermal insulation class of the actuator H
    Nominal operation/Duty cycle 100 %
    Switch time open min 100 ms
    Switch time open max. 200 ms
    Switch time close min 300 ms
    Switch time close max. 500 ms
    Valve setting opening time No
    Valve setting closing time No
    Back-pressure-resistant version No
    Vacuum version No
    Analysis version No
    Oxygen version No
    Oil burner valve No
    Steam version No
    Pilot control orifice (mm) 0.9 mm
    Pilot control seal material PCTFE (Polychlortrifluorethylene)
    Low-noise version No
    Main valve with integrated screen No
    Installation length 50 mm
    Without mounting No
    Valve construction Valve complete
    Vægt 1,600000 kg
    Vis hele tabellen Reducér tabel

    Downloads

    Datablad

    Beskrivelse
    Filstørrelse
    Sprog / Land
    DTS Type 2400 data sheet | servo-assisted piston valve 247,6 kB EN / EU
    DTS Type 2400 data sheet | servo-assisted piston valve [US units] 247,3 kB EN / US
    DTS Typ 2400 Datenblatt | servogesteuertes Kolbenventil 249,4 kB DE / DE
    DTS Type 2400 fiche technique | Électrovanne assistée à piston pour hautes pressions 357,3 kB FR / FR

    Brugermanualer

    Beskrivelse
    Filstørrelse
    Sprog / Land
    MAN Additional manual Type 0721 | Type X, IIC 2G Ex mb or IIC 2G Ex e mb ATEX-approval 598,2 kB EN / EU
    MAN Operating Instructions Type 2400 | 2/2-way solenoid-operated valve 310,6 kB ,EN,FR,DE,IT,ES / EU
    MAN Bedienungsanleitung Typ 2400 | 2/2-Wege-Magnetventil, DN5 /DN8 655,4 kB DE / DE
    MAN Manuel supplémentaire Type 0407 | Type X, IIC 2G Ex mb, IIC2G Ex e mb homologation ATEX 601,8 kB DE / FR
    MAN Zusatzanleitung Typ 0721 | Type X, IIC 2G Ex mb bzw. IIC 2GEx e mb ATEX-Zulassung 586 kB DE / DE

    EU-erklæring

    Beskrivelse
    Filstørrelse
    Sprog / Land
    ABD EU-DoC|EU Declaration 1,7 MB EN,FR,DE

    Min sammenligningsliste